Firmware Pycom FIPY with OTA
| File systems | RAMFS, SPIFFS. |
| Lua modules | adc, bt, can, cjson, cpu, encoder, event, fs, gdisplay, i2c, lora, mqtt, neopixel, net, nvs, pack, pio, pwm, sdisplay, sensor, servo, socket, spi, stepper, thread, tmr, uart, ulp. |
| Networking | WiFi. |
| Network services | CAN gateway, Captive DNS, Dropbear SSH server, HTTP server, SNTP. |
| Sensors | 10K Thermistor, 2P toggle switch, 2Y0A21, 3P toggle switch, 4x4 key matrix, A49E, Analog joystick, BDE0600G, BH1620FVC, BH1721FVC, BME280, DHT11, DHT22, DHT23, DS1820, GPS, GUVA S12SD, Hall flow sensor, Hall internal, Hall switch, LDR, LM35, Linear potentiometer, ML8511, PING28015, PIR AM412, Push switch, Relative rotary encoder, SDS011, TMP36, Tilt switch, US015. |
| CAN | Signal | GPIO |
|---|---|---|
| 0 | RX TX |
GPIO35 GPIO25 |
| I2C | Signal | GPIO |
|---|---|---|
| 0 | SCL SDA |
GPIO25 GPIO26 |
| 1 | SCL SDA |
GPIO2 GPIO15 |
| SPI | Signal | GPIO |
|---|---|---|
| 2 | MISO MOSI CLK |
GPIO12 GPIO13 GPIO14 |
| 3 | MISO MOSI CLK |
GPIO19 GPIO27 GPIO5 |
| UART | Signal | GPIO |
|---|---|---|
| 0 | RX TX |
GPIO3 GPIO1 |
| 1 | RX TX |
GPIO26 GPIO25 |
| 2 | RX TX |
GPIO2 GPIO15 |
| SD/MMC | Signal | GPIO |
|---|---|---|
| 0 | CMD CLK DAT0 CD WP |
GPIO15 GPIO14 GPIO2 Not used Not used |
| Display signal | GPIO |
|---|---|
| MISO MOSI CLK CS RST CMD BCKL* |
GPIO19 GPIO27 GPIO5 GPIO13 GPIO14 GPIO12 Not used |
* back light
| Touch panel signal | GPIO |
|---|---|
| MISO MOSI CLK CS |
GPIO19 GPIO27 GPIO5 GPIO16 |
| Signal | GPIO |
|---|---|
| SCL SDA |
GPIO25 GPIO26 |
Lua RTOS is free for you, but funds are required to make this possible. Feel free to donate as little or as much as you wish. Every donation is very much appreciated.
