Skip to content

supervisor_failure_test

Github Action edited this page Jul 9, 2024 · 3 revisions

TE-8.2: Supervisor Failure

Summary

Ensure that gRIBI entries are persisted over supervisor failure.

Procedure

  • Connect DUT port-1 to ATE port-1, DUT port-2 to ATE port-2. Assign IPv4 addresses to all ports.

  • Connect gRIBI client to DUT specifying persistence mode PRESERVE, SINGLE_PRIMARY client redundancy in the SessionParameters request, and make it become leader. Ensure that no error is reported from the gRIBI server.

  • Add an IPv4Entry for prefix 203.0.113.0/24 pointing to ATE port-2 via gRIBI-A. Ensure that the entry is active through AFT telemetry and correct ACK is received.

  • Send traffic from ATE port-1 to prefix 203.0.113.0/24, and ensure traffic flows 100% and reaches ATE port-2.

  • Validate: Traffic continues to be forwarded between ATE port-1 and ATE port-2 during supervisor switchover triggered using gNOI SwitchControlProcessor.

    Following reconnection of a gRIBI client to new master supervisor , ensure the prefix 203.0.113.0/24 pointing to ATE port-2 is present and traffic flows 100% from ATE port-1 to ATE port-2.

OpenConfig Path and RPC Coverage

The below yaml defines the OC paths intended to be covered by this test. OC paths used for test setup are not listed here.

paths:
    ## Config Parameter coverage

    ## Telemetry Parameter coverage

    /components/component/state/last-reboot-time:
     platform_type: ["CHASSIS", "CONTROLLER_CARD"]
    /components/component/state/last-reboot-reason:
     platform_type: ["CHASSIS", "CONTROLLER_CARD" ]
    /components/component/state/redundant-role:
     platform_type: [ "CONTROLLER_CARD" ]
    /components/component/state/last-switchover-time:
     platform_type: [ "CONTROLLER_CARD" ]
    /components/component/state/last-switchover-reason/trigger:
     platform_type: [ "CONTROLLER_CARD" ]
    /components/component/state/last-switchover-reason/details:
     platform_type: [ "CONTROLLER_CARD" ]

rpcs:
    gnmi:
        gNMI.Set:
        gNMI.Get:
        gNMI.Subscribe:
    gnoi:
        system.System.SwitchControlProcessor:

Minimum DUT Required

vRX - Virtual Router Device

Clone this wiki locally