Skip to content

singleton_test

Jump to bottom
Github Action edited this page Oct 3, 2024 · 8 revisions

RT-5.1: Singleton Interface

Summary

Singleton L3 interface (non-LAG) is supported on DUT.

Testbed type

Procedure

For each port speed and breakout port configuration that need to be tested, add a new testbed configuration with the desired port types.

  • Configure ATE port-1 connected to DUT port-1, and ATE port-2 connected to DUT port-2, with the relevant IPv4 and IPv6 addresses.
  • Configure static MAC address to be 02:1a:WW:XX:YY:ZZ where WW:XX:YY:ZZ are the octets of IPv4.
    • Ensure: ARP discovers static MAC address specified when port is configured with static MAC.

RT-5.1.1 - singleton interface verification:

  • Validate that port speed is reported correctly and that port telemetry matches expected negotiated speeds for forced, auto-negotiation, and auto-negotiation while overriding port speed and duplex.
    • TODO: If the port is a breakout, ensure that all breakout ports are correctly reported.
  • For IPv4 and IPv6:
    • With traffic flow from ATE port-1 to ATE port-2, ensure:
      • For MTUs [^1] of 1500, 5000, 9236:
        • Packets with size greater than the configured MTU with DF-bit set are not transmitted.
        • Packets with size of configured MTU are received.
        • Packets with size less than the configured MTU are received.

[^1]: The MTU specified above refers to the L3 MTU, which is the payload portion of an Ethernet frame.

RT-5.1.2 - link flaps:

  • Bring down the physical layer of ATE port-1, and bring it back up. Repeat this a few times (minimum 2)
    • Verify that the interface goes down by checking the physical state on DUT/ATE.
    • Verify that the interface is back up by checking the physical state on DUT/ATE.
    • Ensure that the number of interface state changes are accurately captured in the OC path.
    • Verify that the traffic flow from ATE port-1 to ATE port-2 is now working after the interface is back up.

RT-5.1.3 [TODO: https://github.com/openconfig/featureprofiles/issues/2320]

Subscribe to interface counters with SAMPLE mode:

  • Run the test twice, once with a SAMPLE interval of 10 Seconds and once again with a SAMPLE interval of 15 seconds
  • Initiate traffic
  • Counters should be verified using gNMI subscribe with sample mode for inbound port (DUT port-1):
    • /interfaces/interface/state/counters/in-unicast-pkts
    • /interfaces/interface/state/counters/in-broadcast-pkts
    • /interfaces/interface/state/counters/in-multicast-pkts
    • /interfaces/interface/state/counters/in-octets
    • /interfaces/interface/state/counters/in-discards
    • /interfaces/interface/state/counters/in-errors
    • /interfaces/interface/state/counters/in-fcs-errors
  • Counters should be verified using gNMI subscribe with sample mode for outbound port (DUT port-2):
    • /interfaces/interface/state/counters/out-unicast-pkts
    • /interfaces/interface/state/counters/out-broadcast-pkts
    • /interfaces/interface/state/counters/out-multicast-pkts
    • /interfaces/interface/state/counters/out-octets
    • /interfaces/interface/state/counters/out-errors
    • /interfaces/interface/state/counters/out-discards
  • Ensure inbound and outbound unicast counters are the same
  • Ensure counters increment at the selected SAMPLE interval

RT-5.1.4 [TODO: https://github.com/openconfig/featureprofiles/issues/2338]

Breakout must be explicitly configured by gNMI client

  • On DUT Port-1 with a QSFP-DD 400GBASE-DR4 transceiver inserted
  • Ensure no breakout is configured
  • Set Port-1 port-speed to 100G
    • /interfaces/interface/ethernet/config/port-speed
  • Validate that the DUT does not create breakouts implicitly and does not set the breakout speed
    • /components/component/port/breakout-mode/groups/group/config
    • /components/component/port/breakout-mode/groups/group/config/index
    • /components/component/port/breakout-mode/groups/group/config/breakout-speed
  • Validate the port state changes to "DOWN"
    • /interfaces/interface/state/oper-status

RT-5.1.5 [TODO: https://github.com/openconfig/featureprofiles/issues/2338]

Setting port-speed on interface that have breakout configured should not be allowed

  • Configure a breakout on Port-1 to 4x100 Gig
    • /components/component/port/breakout-mode/groups/group/config
  • Try to set port speed of Port-1 to 100G
    • /interfaces/interface/ethernet/config/port-speed
  • Validate the port-speed is rejected
    • Since a breakout port is not expected to support port-speed, verify the gNMI Set operation is rejected
    • /interfaces/interface/ethernet/state/port-speed

RT-5.1.6 [TODO: https://github.com/openconfig/featureprofiles/issues/2338]

Remove breakout and interface config to delete the interface config

  • Using a single gNMI Replace, remove the DUT port-1 and its breakout config
  • Ensure the gNMI Replace is successful and configuration for DUT port-1 including its breakout is removed
    • /interfaces/interface/ethernet/state/
    • /components/component/port/breakout-mode/groups/group/state

Config Parameter Coverage

  • /interfaces/interface/config/name
  • /interfaces/interface/config/description
  • /interfaces/interface/config/enabled
  • /interfaces/interface/subinterfaces/subinterface/ipv4/config/mtu
  • /interfaces/interface/subinterfaces/subinterface/ipv6/config/mtu
  • /interfaces/interface/config/id
  • /interfaces/interface/ethernet/config/mac-address
  • /interfaces/interface/ethernet/config/port-speed
  • /interfaces/interface/ethernet/config/duplex-mode

Telemetry Parameter Coverage

  • /interfaces/interface/ethernet/state/counters/in-mac-pause-frames
  • /interfaces/interface/ethernet/state/counters/out-mac-pause-frames
  • /interfaces/interface/ethernet/state/mac-address
  • /interfaces/interface/state/counters/in-broadcast-pkts
  • /interfaces/interface/state/counters/in-discards
  • /interfaces/interface/state/counters/in-errors
  • /interfaces/interface/state/counters/in-multicast-pkts
  • /interfaces/interface/state/counters/in-octets
  • /interfaces/interface/state/counters/in-unicast-pkts
  • /interfaces/interface/state/counters/in-unknown-protos
  • /interfaces/interface/state/counters/out-broadcast-pkts
  • /interfaces/interface/state/counters/out-discards
  • /interfaces/interface/state/counters/out-errors
  • /interfaces/interface/state/counters/out-multicast-pkts
  • /interfaces/interface/state/counters/out-octets
  • /interfaces/interface/state/counters/out-pkts
  • /interfaces/interface/state/counters/out-unicast-pkts
  • /interfaces/interface/subinterfaces/subinterface/ipv4/state/mtu
  • /interfaces/interface/subinterfaces/subinterface/ipv6/state/mtu
  • /interfaces/interface/state/oper-status
  • /interfaces/interface/subinterfaces/subinterface/ipv4/addresses/address/ip
  • /interfaces/interface/subinterfaces/subinterface/ipv4/state/counters/in-pkts
  • /interfaces/interface/subinterfaces/subinterface/ipv4/state/counters/out-pkts
  • /interfaces/interface/subinterfaces/subinterface/ipv6/addresses/address/ip
  • /interfaces/interface/subinterfaces/subinterface/ipv6/state/counters/in-discarded-pkts
  • /interfaces/interface/subinterfaces/subinterface/ipv6/state/counters/in-pkts
  • /interfaces/interface/subinterfaces/subinterface/ipv6/state/counters/out-discarded-pkts
  • /interfaces/interface/subinterfaces/subinterface/ipv6/state/counters/out-pkts
  • /interfaces/interface/ethernet/state/aggregate-id
  • /interfaces/interface/ethernet/state/port-speed
  • /interfaces/interface/state/admin-status
  • /interfaces/interface/state/counters/out-octets
  • /interfaces/interface/state/description
  • /interfaces/interface/state/type
  • /interfaces/interface/subinterfaces/subinterface/ipv6/state/counters/out-forwarded-pkts
  • /interfaces/interface/state/hardware-port
  • /interfaces/interface/state/id
  • /interfaces/interface/state/counters/in-fcs-errors
  • /interfaces/interface/state/counters/carrier-transitions

Protocol/RPC Parameter Coverage

  • gNMI
    • Get
    • Subscribe

Minimum DUT Platform Requirement

vRX

OpenConfig Path and RPC Coverage

The below yaml defines the OC paths and RPC intended to be covered by this test.

paths:
  /interfaces/interface/ethernet/state/counters/in-mac-pause-frames:
  /interfaces/interface/ethernet/state/counters/out-mac-pause-frames:
  /interfaces/interface/ethernet/state/mac-address:
  /interfaces/interface/state/counters/in-broadcast-pkts:
  /interfaces/interface/state/counters/in-discards: 
  /interfaces/interface/state/counters/in-errors:
  /interfaces/interface/state/counters/in-multicast-pkts:
  /interfaces/interface/state/counters/in-octets:
  /interfaces/interface/state/counters/in-unicast-pkts:
  /interfaces/interface/state/counters/in-unknown-protos:
  /interfaces/interface/state/counters/out-broadcast-pkts:
  /interfaces/interface/state/counters/out-discards:
  /interfaces/interface/state/counters/out-errors:
  /interfaces/interface/state/counters/out-multicast-pkts:
  /interfaces/interface/state/counters/out-octets:
  /interfaces/interface/state/counters/out-pkts:
  /interfaces/interface/state/counters/out-unicast-pkts:
  /interfaces/interface/subinterfaces/subinterface/ipv4/state/mtu:
  /interfaces/interface/subinterfaces/subinterface/ipv6/state/mtu:
  /interfaces/interface/state/oper-status:
  /interfaces/interface/subinterfaces/subinterface/ipv4/addresses/address/ip:
  /interfaces/interface/subinterfaces/subinterface/ipv4/state/counters/in-pkts:
  /interfaces/interface/subinterfaces/subinterface/ipv4/state/counters/out-pkts:
  /interfaces/interface/subinterfaces/subinterface/ipv6/addresses/address/ip:
  /interfaces/interface/subinterfaces/subinterface/ipv6/state/counters/in-discarded-pkts:
  /interfaces/interface/subinterfaces/subinterface/ipv6/state/counters/in-pkts:
  /interfaces/interface/subinterfaces/subinterface/ipv6/state/counters/out-discarded-pkts:
  /interfaces/interface/subinterfaces/subinterface/ipv6/state/counters/out-pkts: 
  /interfaces/interface/ethernet/state/aggregate-id:
  /interfaces/interface/ethernet/state/port-speed:
  /interfaces/interface/state/admin-status:
  /interfaces/interface/state/description:
  /interfaces/interface/state/type:
  /interfaces/interface/subinterfaces/subinterface/ipv6/state/counters/out-forwarded-pkts:
  /interfaces/interface/state/hardware-port: 
  /interfaces/interface/state/id:
  /interfaces/interface/state/counters/in-fcs-errors:
  /interfaces/interface/state/counters/carrier-transitions:

rpcs:
  gnmi:
    gNMI.Set:
      union_replace: false
    gNMI.Subscribe:
      on_change: false
Clone this wiki locally