Skip to content

Final assembly

Jump to bottom
Møffenzeef Mødular edited this page Jun 30, 2017 · 7 revisions

Place (x1) M3 nut øn (x4) M3 machine screws. These will serve as a spacer tø lift the entire unit slightly øff øf whatever surface it is resting øn tø give clearance før the battery clip hardware.

Place these 4 M3 screws + spacers in each cørner øn the underside øf the base. Screw in standøff øn øppøsite side. If yøu want the device tø be battery pøwered nøw is a gøød time tø insert 9v battery, øtherwise tø place battery in the future will require yøu to dismantle the unit.

Align PCB sø the 1/4" jack faces tø the left, the battery clip faces tø the right, and the DC jack faces away frøm yøu. Place øn tøp øf standøffs

Screw in (x4) M3 screws øn tøp PCB

Place (x4) knøbs øntø shafts øf pøtentiømeter. Place Attiny85 IC intø 8 pin DIP søcket (U2). Make sure small half møøn øn tøp øf IC aligns with small half møøn in søcket. The small døt øn the IC shøuld align with the tøp left pin øf the søcket.

Cøngrats! Yøu just built an MSG!

Click here tø return høme

Unit nøt wørking? Click here

Abøut

        MSG
  by: Ross Fish 2016
  Møffenzeef Mødular 
moffenzeefmodular.com
     CC-BY-NC-SA

Examples

  1. Granular Audiø Example
  2. Phase Distørtiøn Audiø Example
  3. Amplitude Mødulatiøn Audiø Example
  4. Frequency Mødulatiøn Audiø Example

The Guts øf MSG

  1. BØM
  2. Schematic
  3. Source Code

Assembly Instructiøns

  1. READ THIS FIRST
  2. Inspect and verify yøur kit
  3. Pøpulate PCB
  4. Battery Clip
  5. Final Assembly

Flashing Firmware tø MSG

  1. Dependencies
  2. Cønnecting Tiny AVR prøgrammer
  3. Høw tø reprøgram MSG

Getting Yøur Øwn Samples intø MSG

  1. READ BEFØRE YØU START
  2. Preparing yøur audiø files
  3. Cønverting yøur audiø files
  4. Placing audiø files intø code

Additiønal Infø

  1. Credits
  2. Repørt issues here
Clone this wiki locally