CB15 Terminal
##CB15 Terminal##
This terminal is meant to connect to the LabJack via the DB15 connector, located on the top of the LabJack (image below). It connects the Arduino to the LabJack via the IDC Parallel Cable.
This terminal allows for the recognition and collection of information regarding nose-pokes. The assignments of these D15 Terminals are listed below.
| Pin # | Pin Name | Description | I/O |
|---|---|---|---|
| 1 | VS | LabJack DC+ Running Wheel Beambreak -"red" wire | - |
| 2 | CIO1 | Running Wheel Beambreak -"IN" | Output |
| 3 | CIO3 | - | Input |
| 4 | E1O0 | Water 1 Beambreak | Input |
| 5 | EIO2 | Food 1 Beambreak | Input |
| 6 | E1O4 | Water 1 Dispense | Input |
| 7 | EIO6 | Food 1 Dispense | Input |
| 8 | GND | Running Wheel Beambreak - "DC-" | - |
| 9 | CIO0 | Running Wheel Beambreak -"white" | Input |
| 10 | CIO2 | - | Input |
| 11 | GND | Running Wheel Beambreak - "green" | - |
| 12 | EIO1 | Water 2 Beambreak | Input |
| 13 | EIO3 | Food 2 Beambreak | Input |
| 14 | EIO5 | Water 2 Dispense | Input |
| 15 | EIO7 | Food 2 Dispense | Input |