V2.0

• Added IMU (ICM42688-P), FSYNC is connected to CMOS's VSYNC output, powered by 1.8V LDO so its power is controlled by camera enable pin. (i.e you need to actively using the camera to enable the power to IMU also).
• Changed the board outline to 39 x 39mm square. Which requires to use vertical 22pin FPC connector and QWIIC connector.
• Adding 0R resistor as a solder bridge for the jumpers to make the PCBA much easier.
• Added U.FL connector for XVS/XHS

V1.4

Update for V1.4

1. Added an ECC608B security chip for those who want to do content authenticity (https://contentauthenticity.org)
2. Moved TMP117 to use 3.3V so the temperature sensor will be active even if the camera is not enabled.
3. Adding jumper point to select pull-up or pull-down for camera enable pin and the option to disconnect the enable pin.
4. Adding a cutout under the sensor for direct sensor cooling.

V1.3

v1.3

Update README.md