2022.08.20

Changes

tch-gui-unhide

• Fixed bug where utilities were always copied to USB during GUI upgrade, even if they didn't exist before
• Fixed bug where Cancel/Save buttons were not replaced with Close button after successfully updating Broadband configuration
• Fixed layout issues and missing status for Mobile Only Mode on Mobile card
• Fixed LAN IPv6 in bridged mode
• Fixed IPv6 DNS Server display on Local Network card when DNS hijacking enabled
• Added Permanent WWAN switch to Broadband Configuration (Thanks to @UncleSam1966 for original code)
  • When enabled, Mobile Internet will be permanently connected at a lower priority so that normal traffic will pass through the WAN connection, but if that fails, traffic will be routed immediately through the WWAN connection)
  • NOTE: Should not be used with Telstra Backup SIM - it will probably get disabled
• Added separate tabs for Fixed and Mobile Broadband Usage
• Added device IPv6 addresses to Local Network card
• Added device IPv6 addresses to Local Network Screen
• Added Statistics tab to Telephony
• Added ability to configure WWAN peer DNS
• Added SIM card service provider to Mobile card header
• Added direct link to SMS tab from Unread SMS count on Mobile card
• Removed "SMS messages not supported with the Telstra Backup SIM" alert if SMS messages were found
• Removed log check during install (not reliable)
• Daily upload/download volume shown on Broadband card includes both Fixed and Mobile usage (not just current active interface)
• Internet card now correctly shows both Fixed and Mobile IPs if both active
• Hide Mobile Only Mode status on Mobile card if WAN Sensing disabled
• Hide Mobile Only Mode switch on Mobile Configuration screen if WAN Sensing disabled
• Hide Mobile Auto-Failover tab if WAN Sensing disabled
• When DNS hijacking enabled, automatically detect additional IPv6 addresses assigned to the specified IPv6 DNS Server (when a WAN interface comes up) and automatically exclude them from interception
• Updated tproxy-go to v2022.08.20-0-gcf5bf47

de-telstra

• WPS setting not correctly applied on FW 20.4 (Smart Modem Gen 3)

log-check

• Removed script (not reliable)

reset-to-factory-defaults-with-root

• When the -i (restore current IP address) option is specified, port forwards, static leases and the IPv6 ULA and prefix size will be restored (unless --no-forwards, --no-leases or --no-ula are specified).

safe-firmware-upgrade

• Fixed saved defaults not correctly applied
• When the -i (restore current IP address) option is specified, port forwards, static leases and the IPv6 ULA and prefix size will be restored (unless --no-forwards, --no-leases or --no-ula are specified).

Download Statistics