UBX Packet Parser

Introduction

This module is able to read from and configure ublox GPS modules through their UBX binary protocol over a serial connection. It can be considered a wrapper around the pyserial module.

A ublox 8 device was used to develop and test this library in combination with the documentation provided by ublox. Many of the messages specified in this document should also be compatible with earlier versions of the device (4/5/6/7) but others might not be backwards compatible.

Test

Move to main directory and issue:

$ python2 -m pytest
$ python3 -m pytest

Supported Messages

• Configuration

  • CFG-MSG (0x06 0x01)
  • CFG-CFG (0x06 0x09)
  • CFG-NAV5 (0x06 0x24)
  • ...

• GPS-Data

  • NAV-POSLLH (0x01 0x02)
  • NAV-DOP (0x01 0x04)
  • NAV-SOL (0x01 0x06)
  • NAV-PVT (0x01 0x07)
  • ...

• Other

  • ACK-NAK (0x05 0x00)
  • ACK-ACK (0x05 0x01)
  • ...

Usage

One would usually create a serial connection to the GPS module and proceed to create an instance of UbxStream through which one reads data and sends configuration messages. The UbxStream class comes with functions to save, load and reset configurations as well as an automated way to disable all enabled-by-default NMEA messages. Of course one can enable/disable specific messages by passing in the documented message class and id. One can auto detect serial ports and set the baudrate for the connection.

Future Improvements

At the moment only activated messages can be read and there is no support yet for polling specific messages. If any desired messages are not included please create an issue.