Low Cost ARM Cortex-A7 Based Embedded Controller
Visit https://github.com/janztec/empc-arpi-linux-drivers/blob/master/README.md#installation-instructions for instructions on how to automatically install drivers and configuration entries to enable the additional features of the emPC-A/RPI (RTC, CAN, RS232/RS485).
Product page: https://www.janztec.com/en/empc-a-rpi.html
FEATURES emPC-A/RPI
- Processor
- Based on Raspberry Pi 2, Model B
- Broadcom BCM2836 processor
- Quad-Core CPU based on ARM Cortex-A7 with 900 MHz
- Fanless cooling concept
- Realtime clock, battery buffered
- Memory
- System memory 1 GB
- External accessible µSD card slot
- Graphics
- HDMI graphic interface
- Connectors
- 1 x 10/100 MBit/s Ethernet
- 4 x USB (v2.0)
- 1 x 9-pin D-SUB connector for serial debug console
- 1 x CAN (ISO/DIS 11989-2, opto-isolated, termination settings via jumper)
- 1 x RS232 (Rx, Tx, RTS, CTS) or switchable to RS485 (half duplex; termination settings via jumper)
- Internal I/O
- 4 x digital inputs (24VDC)
- 4 x digital outputs (24VDC)
- Power Supply
- Input 9 … 32 VDC
for more information on how to compile this repository visit https://github.com/raspberrypi/linux/blob/rpi-3.18.y/README
Before compiling this kernel sources, make sure that "bcm2709_defconfig" configuration is loaded and the following entries are configured as modules in "menuconfig":
- (M) SC16IS7xx serial support