These are quick and dirty firmwares in various stages of completeness. Source code will follow once I tidy up and release the pot library they use.
Trigger input using RESET CV
Trigger output on OUT
Control gravity and bounce with station and start pots — start with them somewhere in the middle
Switch between trigger and CV out with the reset button
To-do: play with state of ball when triggered- relate to current environment
Trigger drum 1 using START CV
Trigger drum 2 using RESET CV
Audio output on OUT
Change drums with pots — STATION = drum 1, START = drum 2
To-do: sort out bass drum sample, add ability to change volume of each drum, add accent on drum 1 with START CV
STATION pot = odd divider
START pot = even divider
Trigger output on OUT
To-do: change dividers using CV inputs
CV/Audio input using STATION
Gate record using RESET (records for length of gate)
Trigger play using START
Audio/CV output using OUT
Trim sample using knobs — STATION = offset, START = length
Tips: set STATION pot to 0, START pot to 100% to play full length sample. If you're using audio then you need to play about with attenuating and offseting the signal using something like an MI Shades module as the CV inputs on Radio Music are only 0-3v
To-do: reset button to change between one-shot and cycle modes
Clock input using RESET
Clock multiplier using STATION POT
CV control of multiplier using STATION CV
Trigger output using OUT
Tips: Station pot controls multiplier from 1 to 32; Station CV control adds to this 0 to 32. LEDs show current multiplication in binary.
To-do: make the Start pot adjust the maximum number of multiplications.