Debug or Flash Zephyr applications using the CLI

These instructions apply to Arduino 101 boards. The debugging and flashing procedures will be identical on other hardware, however it is likely that you will need to connect your JTAG debugger and serial cable in a different way.

1 . Connect JTAG and your serial cable by following the instructions on the Zephyr website

2 . Install FTDI drivers

• To see serial output from the device, you need the ftdi vcp drivers. These turn the usb connection into a windows com port that you can point putty at. These can be found on the FTDI website
• Please follow the install guide which will guide you through the process of opening the Windows device manager,finding the new device and updating the drivers

3 . Open Device Manager and note the COM port exported by your serial cable

4 . Download putty, launch it and configure the COM port captured from the previous step as shown below. Click "Open"

5 . Download Zadig and launch it

6 . Install libusbk drivers to one of the Flyswatter interfaces

OR

7 . Download the Zephyr image flashing/debugging tools for Windows

Execute the following command from within the Docker Quickstart Terminal:

git clone https://github.com/todorez/zephtools.git

8 . Flash Zephyr image

Typically both the x86 and ARC binaries are named zephyr.bin. Open the Windows CMD terminal and execute the following commands from within the zephtools directory

• To flash the X86/Quark core:

  zephflash.bat -b arduino_101 x86_image_file_to_flash
  

  Example:

  zephflash.bat -b arduino_101 C:\Users\*your_username*\crops-workspace\zephyr-project\samples\nanokernel\apps\philosophers\outdir\zephyr.bin
  

• To flash the Arc core:

  zephflash.bat -c -b arduino_101 image_file_to_flash
  

  Example:

zephflash.bat -b arduino_101 -c C:\Users\*your_username*\crops-workspace\zephyr-project\samples\nanokernel\apps\philosophers\outdir\zephyr.bin

9 . Debug image

• Halt the target:

  Execute the following command from within the Windows CMD terminal:

  zephflash.bat -b arduino_101 -d
  

• Launch the debugger

  Execute the following command from within the Docker Quickstart Terminal to launch the debugger:

  /c/Users/username/.crops/gdb.zephyr path_to_img_with_dbg_symbols
  

  Example:

  /c/Users/username/.crops/gdb.zephyr /crops/zephyrproject/samples/nanokernel/apps/philosophers/outdir/zephyr.elf
  

• Connect the debugger to the target:

  To connect to the x86 core:

  target remote 192.168.99.1:3334
  

  To connect to the ARC core:

  target remote 192.168.99.1:3333
  

** Note: Since the x86 core gates/controls the serial port from Message Q, it isn't possible/feasible to debug the arc core while the X86 core is halted since if the Arc core is pushing out serial info, then it will get stuck/full mbox since the X86 core is halted.**