Debug or Flash Zephyr applications using the CLI

These instructions apply to Arduino 101 boards. The debugging and flashing procedures will be identical on other hardware, however it is likely that you will need to connect your JTAG debugger and serial cable in a different way.

1 . Connect JTAG and your serial cable by following the instructions on the Zephyr website

2 . Open Device Manager and note the COM port exported by your serial cable

3 . Download putty, launch it and configure the COM port captured from the previous step as shown below. Click "Open"

4 . Download Zadig and launch it

5 . Install libusbk drivers to all Flyswatter interfaces

Download the zflash tool for Windows

Flash image

Debug image