Please Note: I don't use this code anymore. I now use an Wemos D1 with ESPEasy on it. The changes I did in IrLib are also ported to the ESPEasy plugin.

EthernetIRSender

Ethernet IR Sender to send IR command through an ethernet enabled Arduino (With Wiznet Ethernet Shield)

• Put an IR led to Pin3 of the Arduino

• Point your browser to the given IP address (default 192.168.38.177, you can change this in the .ino file)

• Click one of the predefined commands

• An URL is formed like: http://192.168.38.177/?code=C0D&p=1&r=1&d=20&f=38
  Where

  • code: is the hexadecimal code of the command (recordable by putting an IR receiver on pin 5)
  • sc = second code: the second (hexadecimal) code for a single command
  • p = protocol: is the protocol to use, for now: 1 = rc5, 2=NEC, 3=Samsung
  • r = repeat: is the number of repeats of the command, defaults to 1
  • d = delay: delay between repetitive commands, in milliseconds.
  • f = frequency: use a different frequency than the default 38Khz. (most IR devices have a frequency somewhere between 36 and 40Khz)

Dependencies

You need my fork of IRLib, since this repo depends on an adjustable frequency in the IRLib library.