Release Notes
This release contains QoL updates and improvements to the official release of the VORON2.4 3d printer.
For more detailed information about V2.4 itself, please refer to the official release notes and the previous update V2.4r1
If you're just getting started with your V2.4 build, the files attached to this release contain the most up-to-date parts required for your Voron 3D printer. If you are currently building, or have already built your V2.4r1, please check the list of fixes and updates below and determine whether you need to update your printer accordingly.
The following fixes and updates have been made since the previous release:
- MGN12 X Axis setup from Trident (originally member contributed)
- (note: as with Trident, the MGN12 setup drops compatibility with the PL series of inductive probes)
- Revised Z drive modules to fit guitar amplifier feet introduced with Trident. Maintains compatibility with compressor feet.
- Requires a modification to the bottom panel for upgrades from V2.4r1. Cut template included in the tools folder.
- New rear skirt layout relocating the power inlet and keystone pieces.
- Most unsupported countersunk bolt holes changed to using the cross-bridge method instead of a chamfer.
- Panel mount clips from Trident
- 1mm foam recommended for the top and rear panels
- 3mm foam for the side panels.
- Mini12864 display housing from Trident and updated for better compatibility with the BTT version of the screen.
- Simplified Z cable chain mounts using one screw and a printed retainer.
- Updated skirt fan mounts using M3 screws and heatsets to mount the fans and fan blanks. Inspiration for the heatset mounting method taken from Ali Express vendor.
- Revised Z gantry blocks with extra material so the printed part touches the panels before the screw heads.
- Updated suggested electronics compartment layout to match Trident.
- Electronics DIN mounting clips from Trident.
- Updated exhaust filter housing with two screws holding the filter access cover.
- Added an exhaust filter fan grill to correct spacing for the fan mounting screws.
- Revised front idlers with tensioning screws moved to be inline with the idler pulleys. Inspiration for this modification taken from Github issue - posted by chrisingham05 (#255 ).
- Added mount for 3x5 WAGO 221 modules for inlet power wiring.
- Updated XY endstop pod compatible with both independent and PCB mounted D2F microswitches.
- Updated pulley jig for spacing assistance on all stepper pulleys and gears.
- Updated assembly manual to reflect the changes introduced by 2.4r2
Special thanks to all the contributors
Thank you to everyone who contributed to this update and reported issues with the original release.