SenseCAP-WeatherStation-Raspberry-Pi-Visualization

Sensecap One 3D visual web page, that runs on Raspberry Pi.

---

1. Prepare

1.1 Hardware

• SenseCAP One
• Raspberry Pi 3B/3B+/4
• Seeed RS-485 Shield for Raspberry Pi

  First of all, the shield needs to be properly plugged in and powered.

1.2 Software

• SenseCAP One Configuration Tool

  Connect PC and "SenseCAP One" through a Type-C cable, and then set Sensecap One's protocol to RS485-ASCII by using the software.

• Node.JS v10.22.x

  If there is not installed on Rapi, try to run the script below, to install a new one.

  curl -L https://raw.githubusercontent.com/tj/n/master/bin/n -o n
  bash n 10
  

---

2. How to use

2.1 Configure your Raspberry Pi

Using raspi-config, to enable the hardware serial /dev/ttyS0.

2.2 Download source and install

SSH into Raspberry Pi and execute the following command.

[email protected]:Seeed-Solution/SenseCAP-WeatherStation-Raspberry-Pi-Visualization.git

mv SenseCAP-WeatherStation-Raspberry-Pi-Visualization /opt/SenseCAP-WeatherStation-Raspberry-Pi-Visualization
cd /opt/SenseCAP-WeatherStation-Raspberry-Pi-Visualization

cd server && install --unsafe
cd website && install --unsafe

# pm2 start
npm install -g -y --unsafe pm2 http-server
pm2 start run-server.sh
pm2 start run-website.sh
pm2 save
pm2 ls

2.3 Access Website

Keep your PC and Raspberry Pi under the same LAN, and then access url http://{Rapi IP}:8080 through your browser.