FreeDi v1.03 release
Changelog:
New: Included the tft version and sw version to show them at the "about menu":
Fixed: Z Position updates frequently now during Z offset calibration.
Fixed: Manual z-offset calibration now show decimal numbers.
Fixed for the image: Set stepper_z position_min to -2 to allow negative movement while z-offset calibrating
New: Changed interface of the Manual measurement menu:
New: If you change the z-offset during a print (baby stepping) a new button "Save z-offset" will appear on the "Printjob done screen"
This will save the new applied z-offset persistent and will restart the printer:
Fixed: "move bed to bottom"-button is working again
Fixed: "Load" and "Unload" filament buttons do now work again at cold nozzles
Changed: Preset temperatures for load and unload filament changed 215°C -> 230°C
New: When pressing the "Load" or "Unload" filament button, the extruder animation starts only when the nozzle temperature is > 215°C
Moonraker updated: v0.9.2-6 > v0.9.3-0
Based on and included
- Armbian 24.2.0 Bookworm 6.6.17 OS
- KIAUH v5.1
- Klipper v0.12.0-289
- Moonraker v0.9.3-0
- Mainsail v2.12.0
- X3seriesLCD v1.00
Current supported printer models:
- X-Max 3
- X-Plus 3
Image for new systems
This release includes an image (*.rar archive -> *.img file when unpacked) to flash a pure and minimal image to your EMMC or USB flahs drive.
See Installation guide for fresh systems how to install it
Software update for existing FreeDi systems
To update the software check out the Updating FreeDi guide
Please head over to the Installation guide section for step by step guides.