Home

Autinn VCV Rack plugin

Click on the right side-menu to see manual for each module.

Currently at version 0.6.4

Bass - Bass/acid synth

Oscillators

Filters

VCAs

1. 1. Digi

Digitizes a voltage, into discrete steps. Steps can be from 0V (smooth) to 1V (very jagged).

Can be used for audio rate as well as CV voltages.


1. 1. Deadband

This is a deadband. The width is how much the deadband zone should be on each side of origin of input. Width can be from 0V to 5V. Optionally the gap can be specified from 0% to 100%. Having a gap means the output will not start from 0V when it passes the width, at 100% gap everything within width will be 0V and everything outside will just as input.


1. 1. Conv

Converts to and from uni/bi CV voltages.


1. 1. DC

AC to DC module.


A typical use for this is to just measure DC offset of audio. Just connect the output to RJModules Display or Fundamentals Scope, and you get a readout of the value. In theory you could also invert the polarity and add it to the audio, and then you have a DC blocker, this I haven't tested though.

The light will be green if DC is low, become more blue for negative DC and more red for positive DC.

Is meant for audio, not CV signals.

1. 1. Flopper

Takes the top part of the wave from input 1, and the lower part from input 2 to output 1.

Does the opposite for output 2.


The knob and CV determines which voltage the switch from top to bottom will take place.

1. 1. Vibrato

Vibrato effect with optional Flanger.

The vibrato is not modulation of volume or pitch, its a real vibrato effect.


No clipping.

1. 1. Vxy

This simulates a x-y coordinate field. Imagine the current point having a velocity vector that is turning with some random speed. That will move the point around in the field. When it hit a boundary (+-5V) it will stay there until the velocity vector directs it away from the boundary again. For this reason the outputs tend to spend around half their time at the extremes.

The speed knob sets the speed the point is moving with.

Suggested usage: For modulating other modules CV inputs in a smooth semi-random way.

+-5V output.


1. 1. Aura

It uses ITD and IID to make stereo panning for headphones.


Use CV to control which pitch is the main freq in the input signal.

You have to press the apply button each time you change the source listening angle with the knob.

1. 1. Rails

Mono to fake stereo converter. It doesn't pan, the output power is still the same in both channels, but a delay in one channel.


Download

here

Feedback and suggestions

Post issues on the page for that. :)

Changelog