Lost configuration after docker pull update #3470
Replies: 2 comments 3 replies
-
This just measn you didn't configured volumes correctly on your docker-compose file. Could you paste your docker-compose file here please? |
Beta Was this translation helpful? Give feedback.
-
|
Ah, thanks. I corrected my docker-compose file. Regards Bert |
Beta Was this translation helpful? Give feedback.
-
|
If you show me I could verify if you did it correctly to prevent the above error |
Beta Was this translation helpful? Give feedback.
-
|
Sure and thank you! changed the extension to txt otherwise it would not upload. |
Beta Was this translation helpful? Give feedback.
-
|
That's ok now, it will create a |
Beta Was this translation helpful? Give feedback.
-
Whenever I update ZWaveJSUI (installed using docker on my raspberry pi), I use the method described here: #2748.
Basically, it boils down to : docker-compose pull && docker-compose up -d
The big disadvantage of this approach is that I must configure ZWaveJSUI from scratch and that it starts scanning all the devices again rebuilding the nodes. Is there an easier way, so that, at least, the existing configuration is reused so that I don't have to reconfigure ZWaveJSUI again?
It would also be useful that the documentation point out how to update to a new version. This topic is currently lacking.
Regards Bert
Beta Was this translation helpful? Give feedback.
All reactions