Is it possible to panelize and generate fabrication files at the same time? #726
-
|
I was able to both generate the fabrication files for a single board and generate a panel of that same single board (using the command line for both, although I used the GUI to generate the configuration JSON file for the panel, as creating the panel via GUI tends to either be too slow or crash my computer), but I'd like to kill those 2 birds with just one stone: create the panel and at the same time the BOM and PNP files necessary for assembly. Is it possible? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 4 replies
-
|
Yes, write a script: I am not a fan of adding extra switches to the panelize commands - it makes it messy. |
Beta Was this translation helpful? Give feedback.
-
I tried that, but it didn't worked as expected. I wasn't able to generate the bom and pick-and-place files correctly. |
Beta Was this translation helpful? Give feedback.
-
|
Well, without further details about the errors or unexpected behavior you observed I am afraid I can't help. |
Beta Was this translation helpful? Give feedback.
-
|
I will try again in a moment, thank you for your patience. |
Beta Was this translation helpful? Give feedback.
-
Now it's working, I was using the wrong command line options. Thank you very much for your time and work, it is awesome! |
Beta Was this translation helpful? Give feedback.
Yes, write a script:
I am not a fan of adding extra switches to the panelize commands - it makes it messy.