-
|
I cannot figure out if it is possible for "frame" type of framing use only cuts in one direction as only one-direction cut is usually required to break a panel (one cur only would make the board stiffer). There seems to be only one option: cuts=true/false controlling it to have either both or none (using lates new kikat). |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 1 reply
-
|
Currently, only the option for both cuts is implemented. I am considering adding separate switches. |
Beta Was this translation helpful? Give feedback.
-
|
Thanks, while at it - it might be also useful to specify "only outer cuts for backbones". Backbones are especially useful to be perpendicular to rails. For lot of small PCB's to keep backbone firm it is much better to avoid their internal mousebites but still be able to break off the rails first (then backbones and then to separate the PCB arrays). |
Beta Was this translation helpful? Give feedback.
-
|
The feature was implemented in 0be82ce |
Beta Was this translation helpful? Give feedback.
The feature was implemented in 0be82ce