bed_mesh.cfg

[bed_mesh]
speed: 100
#   The speed (in mm/s) of non-probing moves during the
#   calibration. The default is 50.
horizontal_move_z: 5
#   The height (in mm) that the head should be commanded to move to
#   just prior to starting a probe operation. The default is 5.
mesh_min: 5,5
#   Defines the minimum x,y coodinate of the mesh for rectangular beds.  This
#   coordiate is relative to the probe's location. This will be the first
#   point probed, nearest to the origin. This parameter must be provided for
#   rectangular beds.
mesh_max: 295,256
#   Defines the maximum x,y coordinate of the mesh for rectangular beds.
#   Adheres to the same principle as mesh_min, however this will be the
#   furthest point probed from the bed's origin. This parameter must be
#   provided for rectangular beds.
probe_count: 15,15
algorithm: bicubic
relative_reference_index: 111
#   For rectangular beds, this is a comma separate pair of integer
#   values (X,Y) defining the number of points to probe along each axis.
#   A single value is also valid, in which case that value will be applied
#   to both axes.  Default is 3,3..
#fade_start: 1.0
#   The gcode z position in which to start phasing out z-adjustment
#   when fade is enabled.  Default is 1.0.
#fade_end: 0.0
#   The gcode z position in which phasing out completes.  When set
#   to a value below fade_start, fade is disabled. It should be
#   noted that fade may add unwanted scaling along the z-axis of a
#   print.  If a user wishes to enable fade, a value of 10.0 is
#   recommended. Default is 0.0, which disables fade.
#fade_target:
#   The z position in which fade should converge. When this value is set
#   to a non-zero value it must be within the range of z-values in the mesh.
#   Users that wish to converge to the z homing position should set this to 0.
#   Default is the average z value of the mesh.
#move_check_distance: 5.0
#   The distance (in mm) along a move to check for split_delta_z.
#   This is also the minimum length that a move can be split. Default
#   is 5.0.
#mesh_pps: 2,2
#   A comma separated pair of integers (X,Y) defining the number of
#   points per segment to interpolate in the mesh along each axis. A
#   "segment" can be defined as the space between each probed
#   point. The user may enter a single value which will be applied
#   to both axes.  Default is 2,2.
#algorithm: lagrange
#   The interpolation algorithm to use. May be either "lagrange"
#   or "bicubic". This option will not affect 3x3 grids, which
#   are forced to use lagrange sampling.  Default is lagrange.
#bicubic_tension: .2
#   When using the bicubic algorithm the tension parameter above
#   may be applied to change the amount of slope interpolated.
#   Larger numbers will increase the amount of slope, which
#   results in more curvature in the mesh. Default is .2.
#relative_reference_index:
#   A point index in the mesh to reference all z values to. Enabling
#   this parameter produces a mesh relative to the probed z position
#   at the provided index.