Simple_CYD_ Stand_Leg

Simple CYD stand leg - Portrait

This is a very simple design that is easy and quick to print for holding your CYD up in portrait.

Printing Details

• You will need to print two of them.
• Supports are needed
• You can increase the layer height on this with very little practical impact (I used 0.28mm layer height and the print took just under and hour for 1)

Additional Hardware Required

• 4no. M3 bolt - length is not really important. Shorter than ~20mm will still be contained the plastic.
• (Optional) A right angle micro USB cable - The CYD can be mounted on stand with the USB cable pointing up, or down. If you point it down, you maybe need to get a right angle cable. The ideal one would be something like this (the retention clips side of the micros USB is on the same side as the cable)