You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
after your change from the default baud rate (115200) to the board's max baud rate i get a endless
"Scanning boards" in the wccagents console log.
I have a "DOIT ESP32 DevKit V1".
With debugging i find out, that the maxBauds is configured with 921600 for this board. After changing this value to 115200 in the monitor.go the wccagent establish the connection between my board an the whitecat ide.
Best regards, Andreas
The text was updated successfully, but these errors were encountered:
Why do you select the baud rate automatically from the usb2serial device?
At the other hand is a static baud rate of 115200 defined for the serial console into the Lua RTOS firmware.
Hi,
after your change from the default baud rate (115200) to the board's max baud rate i get a endless
"Scanning boards" in the wccagents console log.
I have a "DOIT ESP32 DevKit V1".
With debugging i find out, that the maxBauds is configured with 921600 for this board. After changing this value to 115200 in the monitor.go the wccagent establish the connection between my board an the whitecat ide.
Best regards, Andreas
The text was updated successfully, but these errors were encountered: