This project is based off of the VCVRack Template at https://github.com/vcvrack/template
You can find patches in examples/ showing off how the modules can be used.
Comparatah compares the CV on the IN port to the knob (0.0v -> 10.0v) below it. If IN is greater than the knob, 10.0V is sent out, if it's less than the knob, 0.0V is sent out. I made this module so I could get a clean timing signal out of my PO-24.
Dividah is a clock frequency divider. IN is the numerator, the 4 outputs (1, 2, 4, 8) are the denominators.
Get Rekt is a rectifier. It outputs the absolute value of the incoming signal.
Hooptie takes Gate CV through the IN port, and sequentially routes it through the output ports. It doesn't always output, though! The higher you turn a step's knob, the more likely it will be to output the CV from IN. The OUT port at the bottom is a union of the 8 ports above it. When you send a rising edge to RST, the sequence will return back to the start.