-
Notifications
You must be signed in to change notification settings - Fork 59
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Can't configure trigger for edge triggering #12
Comments
Trigger commands must be written one per line. Your second example, if entered correctly, should trigger on a falling edge on input PB11.
Enter a plain |
For some reason, the text is shown in a single line, but I copied the output from a plain trigger. |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
I am using
logic
command in order to record a digital signal of about 19.2 kbaud and I want to set trigger in falling edge.I tried this:
$1.50: trigger trigger 0=0xxxxxxx-1-0 st1 trigger 1=1xxxxxxx-0-1 st2
logic
doesn't capture anything.I also tried to reverse the logic:
$1.50: trigger trigger 0=1xxxxxxx-1-0 st1 trigger 1=0xxxxxxx-0-1 st2
Also, no 0 catches samples.
$1.50: trigger trigger 0=0xxxxxxx-0-1 st1 trigger 1=1xxxxxxx-1-0 st2
Captures the signal, but it complains about:
Infinite triggers "pass" loop: 1 -> 1
. In this case the digital signal is broken and not correctly shown as with the next command.If I try with this trigger:
trigger 0=0xxxxxxx-0-0 st1
I get samples and I see the signal.
However,
trigger 0=1xxxxxxx-0-0 st1
doesn't trigger logic although I would expect the same behavior as before.The text was updated successfully, but these errors were encountered: