Skip to content

Pulls data from RCT Power GmbH devices for use with monitoring systems.

License

Notifications You must be signed in to change notification settings

svalouch/rctmon

Repository files navigation

Metrics extractor for RCT Inverters

Tool to extract metrics from a single solar inverter by RCT Power GmbH, using their proprietary Serial Communication Protocol. The project is not in any way affiliated with or supported by RCT Power GmbH. Use at your own risk.

It extracts a subset of the metrics available, mainly the most interesting ones that are presented to users in the official RCT smartphone apps overview screen.

Data can be exposed via a Prometheus compatible endpoint or pushed to an InfluxDB (versions 1.8 and 2.x), or both at the same time. The smartphone app can be used at the same time it is running, but both parties will start to receive invalid frames, so updating the view in the app and updating metrics in rctmon will slow down because of that. The application should be stopped during firmware update as a precautionary measure.

The project is still in its early stages of development. Metric names in the Prometheus export as well as measurement and field names pushed to InfluxDB may change without notice.

Installation

Install and update using pip:

$ pip install -U git+https://github.com/svalouch/rctmon

Configuration example

See the config.example.yml in the projects root folder. As an InfluxDB setup requires some more moving parts, the setup for that is in the documentation. Here is a minimal version to get going with a Prometheus endpoint that is far easier to configure.

Assuming the inverter is at 192.168.0.1:8899, a minimal configuration could look like this:

---
device:
  host: 192.168.0.1
  port: 8899

prometheus:
  enable: true
  exposition: true

influxdb:
  enable: false

Then start the application: rctmon -c <configfile.yml> daemon

Quick peek at the metrics: curl localhost:9831/metrics. Note that the application needs to discover the inverters setup first (how many batteries, is a power switch available and so on) and thus takes a moment for all the metrics to appear.

Debugging

For most problems, starting the application in Debug Mode is sufficient. Simply add --debug, like so: rctmon --debug -c <configfile.yml> daemon and watch the output. Another way is to configure the Python logging infrastructure, see the logging key in the config.example.yml example config file.

To figure out what's going on on the wire, capture the packets with tcpdump or wireshark, if other devices such as smartphones are accessing the inverter at the same time it may be required to capture the data at a point where these flows are visible too, such as the router. The dump can then be viewed using the read_pcap.py tool from the rctclient project.