Skip to content

Latest commit

 

History

History
69 lines (45 loc) · 2.44 KB

Configuring_TunerStudio.md

File metadata and controls

69 lines (45 loc) · 2.44 KB
Raw
title description published date tags editor dateCreated
Configuring TunerStudio project options
true
2022-04-01 21:11:41 UTC
undefined
2020-01-06 01:37:04 UTC

Configuring TunerStudio Project Properties

The menu option for the project properties page can be found here

ts_9_2.png{.align-center width=400}

Once opened this page will be seen.

ts_4_2.png{.align-center width=350}

Settings Tab

The Settings tab does not affect the tune directly, but does change the way some things are displayed within Tuner Studio. Some menus are hidden by default, either for safety reasons or because they are still under development, and they can be enabled here.

Lambda Display

This changes whether the oxygen sensor reasons are shown in AFR (default) or Lambda.

Temperature Display

The temperature selection changes all degrees values within TunerStudio.

  • Fahrenheit(Default)
  • Celsius

Changing this value does not alter the values in tune at all, only which scale the values are displayed in {.is-info}

Enable Hardware Test

The hardware testing dialog allows you to manually turn the ignition and injection outputs on and off in order to test that the circuits are working. This can be dangerous if the outputs are connected to hardware however and so this dialog must be explicitely enabled.

Please ONLY turn this on when the ECU is not connected to a vehicle {.is-danger}

If Enabled, an additional Tab will appear on the tuning page

Project Settings{.align-center width=400}

Reset control features

An optional Speeduino specific boot loader is available that has different methods of controlling the automatic reset. The vast majority of users should leave this on the default 'Basic options only'

Controller in use

Select correct processor type that Speeduino board uses. Typically this is left to default (Arduino MEGA 2560)

  • Arduino Mega 2560(Default)
  • STM32
  • Teensy

NEW_COMMS

To change between new and old comms protocol. Typically this is left to default (NEW_COMMS Activated)

CAN_COMMANDS

Setting not currently in use.

CAN Devices Tab

CAN options are currently under development, but settings are available on this tab for testing if you have supported hardware.

CAN Devices{.align-center width=400}

Configuration of CAN devices is currently unsupported