smart lcd controller

[matrix77]

Hi
can you help me with the last no servo firmware the smart lcd controller not working.the display is blank..
..I try with the previous firmware and it works I have to enable in the configuration.h
this line:
//#define ULTRA_LCD //general LCD support

But this thing doesn't work with this new firmware.
The lcd Pcb is red version.

[3machine]

Is u8glib up to date?
https://code.google.com/p/u8glib/

[smartfriendz]

Hi Matrix77,
Strange. I think we have the same lcd ( i have the cheap red ones) . Did you see at the beginning on the configuration.h there is a "//#define LCDreprapdiscount" . try to uncomment and tell me what happen ?
It works for me here.
I didn't work with the full graphic cd for now , as i don't have here actually.

[R4C3R]

I had the same problem, however in my case it appeared that the contrast of
the display was all the way turned down (little pot which you can turn with
a screwdriver).

Regards,
R4C3R

2014-07-15 13:23 GMT+02:00 smartfriendz [email protected]:

Hi Matrix77,
Strange. I think we have the same lcd ( i have the cheap red ones) . Did
you see at the beginning on the configuration.h there is a "//#define
LCDreprapdiscount" . try to uncomment and tell me what happen ?
It works for me here.

—
Reply to this email directly or view it on GitHub
#6 (comment).

[matrix77]

I try this method (#define LCDreprapdiscount) and the display its working..thank u very much...I have other issue with this firmware. .I try to write tomorrow.