Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Jump to bottom

Which resistors instead of glued BF350? #149

Open
DennisCor opened this issue Nov 23, 2023 · 2 comments
Open

Which resistors instead of glued BF350? #149

DennisCor opened this issue Nov 23, 2023 · 2 comments

Comments

@DennisCor
Copy link

Hi,
you wrote that in v0.5 you replaced the glued BF350 with footprints for SMD resistors. Which type of SMD resistors do I need to make it work with the HX711. Just default 330 ohm SMD?
@DerSpatz
Copy link

According to the schematic, yes. Footprint is 2510,

@Bob0x00
Copy link

Bob0x00 commented Dec 6, 2023

Is it ok to solder the resistor directly to the printed circuit board? Or do I need to apply some glue between the resistor and the printed circuit board? After soldering, I can't get the circuit to detect the press action, how do I troubleshoot this? Thank you very much!

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Assignees
No one assigned
Labels
None yet
Projects
None yet
Milestone
No milestone
Development

No branches or pull requests
3 participants
@DennisCor @DerSpatz @Bob0x00