Picture from previous surface shown when jumping between marks (still picture)

[Space2Man]

Hi,

I just noticed something "weird" ... I have prepared the marks to cut the movie and wanted to check if the marks are correct. So I jumped via 7 to the first mark and it showed the first picture of the movie. About 1-2s later the last picture of the movie is shown and it remains there ... so I jumped to the end of the movie via 9 and it shows the end of the movie ... 1-2s later it showed the first picture.

Maybe it shows the picture that was in the buffer for deinterlacing? I need to double check if it happens on SD recordings as well but I noticed it on HD recording from ARD where I have deinterlacing set to NONE.

[Space2Man]

But in the cut movie this is not happening if I jump from beginning to end and vice versa ...

[Space2Man]

Different recording: it takes 1-2s until the correct picture is shown after the jump ... so if I am at the last mark of the recording and jump to the first one then the picture of the end mark is show for 1-2s until it get's updated with the picture of the first mark ...

[rofafor]

Unable to reproduce this with the current master.

[Space2Man]

Ok, I will update and retest ...