allow IBM I: Go to file... to open member when not found

[m-tyler]

I genuinely like the command IBM I: Go to file...

I USE IT ALL THE TIME.

It does have one lacking feature, which I only bring up because of a little bit of ignorance on my part. I was searching for a member, it was not in the list, so in the empty input box (also no results appear), I just started typing the member to open as I do with the command IBM I: Open File. When I press Enter nothing happens. It might seem obvious to you those who wrote the command IBM I: Go to file... but if I was not closely paying attention I am wondering why the open command is no longer working.

So if I type a member path in the IBM I: Go to file... input can it open a member like IBM I: Open File command?

Thanks

[worksofliam]

Good idea. I'd need to look into if the API can support this functionality. Then perhaps we can merge this functionality together.

[m-tyler]

Thanks. No rush from my perspective as I have learned my lesson about the two commands and it's a simple ESC key to be able to trigger off the other.

[m-tyler]

this feature request has been implemented and it works wonderfully.