Skip to content

Latest commit

 

History

History
100 lines (60 loc) · 3.08 KB

README.md

File metadata and controls

100 lines (60 loc) · 3.08 KB
Raw

OpenCS18

Open source Linux platform for Presonus Studiolive CS18AI

Become a patron!

Please support this project on Patreon

Prerequisites

You need docker to be configured on host machine.

Build

Make sure submodules are initialized:

git submodule update --init

Build Docker image

./build-env.sh

Run into docker container

./run.sh

Initialize the configuration, including the defconfig and this external directory:

make opencs18_defconfig

And compile:

make

This may take a couple hours to do from scratch, depending on the speed of your machine.

Saving configuration changes

This saves defconfig of buildroot, busybox and linux kernel. All others changes should be saved manually

../savedef.sh

Boot

After build is finished, copy three files

buildroot/output/images/uImage.presonus-cs18ai
buildroot/output/images/rootfs.squashfs
buildroot/output/images/recovery.scr

on USB stick. Then

  • Power off the unit
  • Place USB stick in USB connector on the rear of the unit
  • Hold Home button
  • Power on the unit
  • Wait bouncing pattern of the meters
  • Release Home button
  • Enjoy benefits of OpenCS18

Using NFS with OpenCS18

Using NFS will dramatically speedup your development process. OpenCS18 usese NFSv4 and awesome NFS docker image

To boot from NFS

Prepare network infrastructure and configure boot parameters in board/opencs18/v1/nfs-bootscript.tmpl the following way

  • Determine your server's IP address that will be visible from your CS18 box.
  • Replace default IP of nfsroot= parameter with your server's IP
  • Ensure CS18 will get its IP using DHCP or edit ip= parameter manually
  • Rebuild images with make build
  • Place resulting /buildroot/output/images/nfs-recovery.scr to USB stick
  • Rename nfs-recovery.scr to recovery.scr, replacing existing file
  • Spin NFS server
  • Boot as usual
  • For questions refer to Kernel's NFS Root manual

Spin NFS server on docker

This shoud be done AFTER build process has finished, because NFS server will bind to buildroot/output/target dir that is created during build step

spin-nfs.sh

It will require your sudo privileges and password to load NFS kernel modules. If you load them yourself, then comment out modprobe command out of the script

NFS Gotchas

  • After running make clean or removing buildroot/output/target dir, you have to restart NFS server with steps above.
  • DNS subsystem is not properly working after system startup at the moment due to absense of /etc/resolv.conf configuration. Use echo nameserver 8.8.8.8 > /etc/resolv.conf to set default google DNS server.

To stop and reload server

Run spin-nfs.sh again

To mount on target

mkdir -p /nfs && mount.nfs4 -v 192.168.10.149:/ /nfs/