-
Notifications
You must be signed in to change notification settings - Fork 130
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Shelly 2.5 shutter only listens to 1 command #760
Comments
Nobody? |
Can't confirm for my Shellys 2.5 (have multiple). |
No problems either with my shelly 2.5. |
I had the same problem. Found that shutter open endstop was at same position as max open. |
my 2.5 was only reading input on chan 1 in detached on official firmware. got it to read by removing neutral loop into first L connection and only using 2nd one then L1 to sensor n back to sw1. both inputs working after that. no issues with mongoose both working after flash |
Same issue here. I've got 6 different shellys and this firmware works perfectly for 5 of them. But for one of my shellies, I can calibrate well, and work fine during 4 or 5 pushes. But at some point, it becomes unresponsive. Can't cancel continuous movement with one push. And both buttons and UI becomes completely unresponsive. It can be during a few seconds, or even indefinitely until new calibration. If I revert to stock firmware, It works perfectly. So I guess hardware is right. Another issue I have seen is that is loosing the connection quite often, even I don't see in the logs, I can see the red flag at the UI for a few seconds. Logs doesn't show any error or disconnection.
|
@masip85 can you please test how the non working Shelly behave on the location and with the window shutter of a working one. I would like to find out what exactly is the problem. |
hard petition,change a shelly is a narrow hand work bad for my back. Isn't enough useful that the shelly works fine with default firmware? |
Ok. Moving it into another window, same kind of bahaviour. This is the log: |
Hi,
I have a Shelly 2.5 in shutter mode with firmware 2.9.5
The problem is the Shelly only acts to 1 command and then doesn't react to any command anymore until its rebooted.
The web GUI is working fine but doesn't accept any up or down command. Same with the Homekit connection.
Tried recalibration a couple of times, tried swapping input and output, all doesn't work.
Shutter works fine with default Shelly 2.5 firmware.
Anybody know what could be wrong here?
Thx,
The text was updated successfully, but these errors were encountered: