-
Notifications
You must be signed in to change notification settings - Fork 6
Final assembly
###Place (x1) M3 nut øn (x4) M3 machine screws. These will serve as a spacer tø lift the entire unit slightly øff ###øf whatever surface it is resting øn tø give clearance før the battery clip hardware.
###Place these 4 M3 screws + spacers in each cørner øn the underside øf the base. Screw in standøff øn øppøsite ###side. If yøu want the device tø be battery pøwered nøw is a gøød time tø insert 9v battery, øtherwise tø place ###battery in the future will require yøu to dismantle the unit.
###Align PCB sø the 1/4" jack faces tø the left, the battery clip faces tø the right, and the DC jack faces away ###frøm yøu. Place øn tøp øf standøffs
###Screw in (x4) M3 screws øn tøp PCB
###Place (x4) knøbs øntø shafts øf pøtentiømeter. Place Attiny85 IC intø 8 pin DIP søcket (U2). Make sure small ###half møøn øn tøp øf IC aligns with small half møøn in søcket. The small døt øn the IC shøuld align with the ###tøp left pin øf the søcket.
###Cøngrats! Yøu just built an MSG!
###Click here tø return høme
###Unit nøt wørking? Click here
MSG
by: Ross Fish 2016
Møffenzeef Mødular
moffenzeefmodular.com
CC-BY-NC-SA
- Granular Audiø Example
- Phase Distørtiøn Audiø Example
- Amplitude Mødulatiøn Audiø Example
- Frequency Mødulatiøn Audiø Example