Sample rate questions

[ssfrr]

I have a few questions related to sample rates:

1. Are there guidelines for choosing the anti-aliasing filter cutoffs, or more information about the filters? Typically I'd want to get rid of frequencies higher than half the sample rate (Nyquist) but without knowing how steep the filter is it's hard to know what the relation between the sample rate and the anti-aliasing filter should be. I'm assuming these filters are analog prior to the sensor's internal ADC, right?
2. The LSM9DS0 is weird in that the accelerometer and gyro units don't sample simultaneously. In your code you're not doing anything fancy to manage the different sample rates or synchronize with the fusion update rate, so from a signal processing standpoint it's equivalent to doing no interpolation (i.e. the signals look like stair-steps). I guess this basically ends up being an additional noise source which the fusion should filter out, but I was wondering if there would be any benefit to interpolating the sensor data readings, basically resampling so that the different signal are synchronized.

If you have any insight based on your experience or from the literature it would be super helpful.

[kriswiner]

Hi Spencer,

Typically the bandwidth is set at 10-20% of the sample rate; I usually use
200 Hz sample rate and 40 or 50 Hz bandwidth with good results, but the
choice does depend on the application. Yes, the signals are analog until
converted to digital by the ASIC.

All 6- and 9-axis motion sensors are the same this way, they read one sensor
at a time ASFAIK. However, you can have the data loaded into the FIFO at a
fixed rate and then burst read the FIFO; this is a way to have the data time
stamped but it isn't really representative of when the analog sensor
experienced the signal, rather when the digitized data was loaded into the
FIFO. Still, this can work for a lot of applications.

I'm afraid I don't have much more to offer.

Kris
-----Original Message-----
From: Spencer Russell [mailto:[email protected]]
Sent: January 1, 2015 2:14 PM
To: kriswiner/LSM9DS0
Subject: [LSM9DS0] Sample rate questions (#5)

I have a few questions related to sample rates:

1. Are there guidelines for choosing the anti-aliasing filter cutoffs,
   or more information about the filters? Typically I'd want to get rid of
   frequencies higher than half the sample rate (Nyquist) but without knowing
   how steep the filter is it's hard to know what the relation between the
   sample rate and the anti-aliasing filter should be. I'm assuming these
   filters are analog prior to the sensor's internal ADC, right?
2. The LSM9DS0 is weird in that the accelerometer and gyro units don't
   sample simultaneously. In your code you're not doing anything fancy to
   manage the different sample rates or synchronize with the fusion update
   rate, so from a signal processing standpoint it's equivalent to doing no
   interpolation (i.e. the signals look like stair-steps). I guess this
   basically ends up being an additional noise source which the fusion should
   filter out, but I was wondering if there would be any benefit to
   interpolating the sensor data readings, basically resampling so that the
   different signal are synchronized.

If you have any insight based on your experience or from the literature it
would be super helpful.

Reply to this email directly or view it on GitHub
#5 .
<https://github.com/notifications/beacon/AGY1qp-93f_I8_sHpocNVF-b21yV914iks5
ndb4VgaJpZM4DNqsf.gif>