Skip to content

Releases: johnnewman/Marlin

2.1.2 - BIGTREETECH SKR Mini 3.0 for Ender 3

23 Feb 02:42
@johnnewman johnnewman
2.1.2-skr-mini-3-ender-3
b662239
Compare
Choose a tag to compare
2.1.2 - BIGTREETECH SKR Mini 3.0 for Ender 3 Latest
Latest

This configuration has worked for me, but you may want to make further tweaks. It's worth comparing the diff of the jn-ender3_skr branch against the 2.1.2 release in case there's a configuration you'd like to tweak. If this is the exact configuration you'd like to use, the attached firmware.bin was compiled with these settings.

Summary of changes:

  • Enabled support for BLTouch/CR Touch.

    • Configured probe offset for CR Touch.

  • Enabled Unified Bed Leveling.

  • Updating probing and mesh margins for default Ender 3 glass clips.

  • Enabling Probe Offset Wizard.

  • Configured USB serial for use with OctoPrint.

  • Calibrated hot end and bed PID.

  • Updated min/max temps and bed size for the Ender-3.

  • Tweaks to use the correct stepper motor inversion on each axis.

  • Enabled Jerk.

  • Enabled linear advance.

  • Enabled EEPROM support.

  • Enabled SD card support.

  • Fan 1 is the part fan that turns on when the hot end is over 160C.

  • Fan 2 is configured as the controller fan to cool the board. It turns to when the stepper motors engage.

  • Configured TMC2209 driver type and enabled TMC debug data.

Assets 3
Loading