Mesh data table and correction visualizer messed up #597
-
|
I increased the width of .container and .span8 with Themeify, but it's the same way with those disabled. |
Beta Was this translation helpful? Give feedback.
Replies: 4 comments 1 reply
-
|
I've only seen the data get messed up like this when the probing points were not equal in both x and y direction, so the probing was like a 2x4 grid instead of a 4x4 grid for example. Other than that it typically only happens when the data gets corrupted and re-probing sometimes will work itself out. |
Beta Was this translation helpful? Give feedback.
-
|
Indeed the bed topography report is missing some values: |
Beta Was this translation helpful? Give feedback.
-
|
|
Beta Was this translation helpful? Give feedback.
-
|
assuming UBL |
Beta Was this translation helpful? Give feedback.
-
|
I had compiled the firmware with the baud rate set to 500k. I think the mainboard (Creality 4.2.7) and/or Octoprint didn't like that for some reason and some characters (esp. newlines) weren't being received properly. Set it back to 250k and everything works correctly. |
Beta Was this translation helpful? Give feedback.
I had compiled the firmware with the baud rate set to 500k. I think the mainboard (Creality 4.2.7) and/or Octoprint didn't like that for some reason and some characters (esp. newlines) weren't being received properly. Set it back to 250k and everything works correctly.