gcode for creality cr-10s pro v2

[homerfoster64]

hi

i cannot seem to get this to work - tried

G28
G29 T

nothing happened

tried the example bilinear and it rose on the z access until it reach the top and tired to keep going up!

any suggestions

thanks

[jneilliii]

My suggestion is to figure out the commands that you need to run to probe your bed. In it's simplest form the plugin should work with

G28
@BEDLEVELVISUALIZER
G29

for bilinear auto bed leveling configured in firmware.

[homerfoster64]

ok will give that a try and let you know when current job finishes

thanks for the quick reply

[homerfoster64]

loaded and now works great - thanks