-
|
So when I create a new mesh via the plugin and do an M500 does that save the new mesh to Slot 1, overwriting what's already there? Can a different slot be specified? Also I see in some examples around the web that a G29 J is executed after loading a new mesh (within the cura start G code settings). I'm not sure what's the point of this if I've already loaded a recently created mesh. Wouldn't the G29 J interefere with the mesh settings? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
|
I'm pretty sure if you don't specify a slot (assuming you're referring to UBL) it gets saved to slot 1, Otherwise you have to use M29 S# or M420 S# to save to a specific slot. I've never used the j option, but the idea is that the mesh is accounting for the bed variance, and then the j is accounting for any changes related to your springs loosening, etc. so it is orbiting the mesh to match the 3 point plane. |
Beta Was this translation helpful? Give feedback.
-
|
Thanks! |
Beta Was this translation helpful? Give feedback.
I'm pretty sure if you don't specify a slot (assuming you're referring to UBL) it gets saved to slot 1, Otherwise you have to use M29 S# or M420 S# to save to a specific slot.
I've never used the j option, but the idea is that the mesh is accounting for the bed variance, and then the j is accounting for any changes related to your springs loosening, etc. so it is orbiting the mesh to match the 3 point plane.