You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Circuit braker like Linky only thrills after 30-60sec giving some time for the power shedding to activate in the house.
Could a parameter be added to only starts power shedding mode only if power exceed capacity after X seconds?
I have an automation to adapt my EV charging rate. But Versatile receive the same power data as the EVSE, and it put the thermostat on power saving mode instantly. The EV charge will takes like 2-3 seconds to adapt its current to capacity. Then the thermostat starts again after this time.
Having the ability to set this delay will prevent those useless cutoff.
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Circuit braker like Linky only thrills after 30-60sec giving some time for the power shedding to activate in the house.
Could a parameter be added to only starts power shedding mode only if power exceed capacity after X seconds?
I have an automation to adapt my EV charging rate. But Versatile receive the same power data as the EVSE, and it put the thermostat on power saving mode instantly. The EV charge will takes like 2-3 seconds to adapt its current to capacity. Then the thermostat starts again after this time.
Having the ability to set this delay will prevent those useless cutoff.
Beta Was this translation helpful? Give feedback.
All reactions