You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hi, I am using iOptron v3 with my iOptron HAZ31 mount, which comes with the Go2Nova hand controller. This controller features an 'Assist Alignment Wizard.' When you execute this function on the hand controller, the mount rotates 360 degrees to the west and ensures the lens is facing upwards, after this the mount is calibrated.
Is there any way to use this functionality through INDI? I have tried the serial communicationb commands ':MSH#' but this just sets the 'zero position' to the position the telescope was in when powered on. The ':CM#' command does nothing.
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Hi, I am using iOptron v3 with my iOptron HAZ31 mount, which comes with the Go2Nova hand controller. This controller features an 'Assist Alignment Wizard.' When you execute this function on the hand controller, the mount rotates 360 degrees to the west and ensures the lens is facing upwards, after this the mount is calibrated.
Is there any way to use this functionality through INDI? I have tried the serial communicationb commands ':MSH#' but this just sets the 'zero position' to the position the telescope was in when powered on. The ':CM#' command does nothing.
Beta Was this translation helpful? Give feedback.
All reactions