battery sensor not working on inav 8 rc3, matek f405 wte

[sys512]

Current Behavior

Battery voltage shown as constant 0 even when battery is connected

Steps to Reproduce

1.Install INAV 8.0.0 RC3 on Matek F405 WTE
2.Configure battery
3.Look at battery voltage
4.Look at the battery voltage again

Expected behavior

Correct battery voltage measurement shown.

---

• FC Board name and vendor: Matek F405 WTE
• INAV version string: INAV/MATEKF405TE_SD 8.0.0 RC3

[MrD-RC]

Is this in configurator or on the OSD?

[sys512]

configurator

[sys512]

i should post this issue in inav configurator repo?

[MrD-RC]

I can move it. Do you see the voltage on the OSD?

[sys512]

I already rolled back to 7.1.2 but ok I'll update and check wait

…

On Sun, Dec 15, 2024, 17:51 Darren Lines ***@***.***> wrote: I can move it. Do you see the voltage on the OSD? — Reply to this email directly, view it on GitHub <#10534 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/BCVCNN4NCILJQQLTH2EGP732FWQQHAVCNFSM6AAAAABTUQM4C6VHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDKNBTHEZDKMRZHA> . You are receiving this because you authored the thread.Message ID: ***@***.***>

[Itay-Sharoni]

Can you make sure UART6 is on MSP mode? i had similar issue but it was due to UART6 was not on MSP mode
Im using SpeedyBee f405 Wing, which is quite similar i believe

(or maybe it is different UART on this FC, just compare the ports sections between 7.12 and 8.0.0)

worth checking :)