Skip to content

Latest commit

 

History

History
42 lines (34 loc) · 1.56 KB

README.md

File metadata and controls

42 lines (34 loc) · 1.56 KB

Galagino cabinet

This is a list of all parts required to build a complete Galagino cabinet from plywood. Further instructions are linked below.

If you don't have access to a laser cutter or prefer a fully 3d printed case then you should have a look at John Bradnam's great Galagino case.

Electric and electronic parts

  • 38 pin ESP32 Devkit
  • 2.8 inch 320x240 ILI9341 display
    • mounted on 50mm x 86mm PCB
    • no touch screen required
  • PAM8302A amplifier
  • cased 3W / 8 ohms speaker as seen e.g. in the cabinet photos
  • 7 x WS2812B LED stripe
    • 7 LEDs cut from a 144 LEDs per meter stripe
  • four 6mm x 6mm push buttons, through hole, height 4.3mm
  • three 6mm x 6mm push buttons, through hole, height 9mm
  • ~50 cm 10 wire flat ribbon cable

Screws and nuts

  • 10 pcs M2 x 8mm screws
  • 6 pcs M2 x 12mm screws
  • one M2 x 16mm screw
  • 14 M2 nuts
    • 6 for the control board, 4 for the cabinet, 4 for the speaker
  • 8 M2 washers
    • 4 for the cabinet, 4 for the control board

Mechanical parts