ParrotFlowerPower

ParrotFlowerPower - Plant Sensor
This module can be used to read data from Parrot Flower Power sensors with bluetooth 4.0 Low Energy.

Requirements:
Gattool is required to use this module. Be sure that bluez is installed (sudo apt-get install bluez).

The Parrot Flower Power sensor can measure the following values:
• temperature
• soil moisture
• light
• fertilizer (not yet supported by the module because the formula to convert the raw value into a useful value is not publicly available)


Installation:
• be sure that bluez is installed: sudo apt-get install bluez
• add the new update site: update add http://raw.githubusercontent.com/mumpitzstuff/fhem-ParrotFlowerPower/master/controls_parrotflowerpower.txt
• run the update and wait until finished: update all
• restart fhem: shutdown restart
• define a new device: define <name of plant> ParrotFlowerPower <mac address of sensor e.g. AA:BB:CC:DD:EE:FF>