CanRetranslatorWithGyro Debug.cfg

# This is an genericBoard board with a single STM32F105R8Tx chip
#
# Generated by STM32CubeIDE
# Take care that such file, as generated, may be overridden without any early notice. Please have a look to debug launch configuration setup(s)

source [find interface/stlink-dap.cfg]


set WORKAREASIZE 0x8000

transport select "dapdirect_swd"

set CHIPNAME STM32F105R8Tx
set BOARDNAME genericBoard

# Enable debug when in low power modes
set ENABLE_LOW_POWER 1

# Stop Watchdog counters when halt
set STOP_WATCHDOG 1

# STlink Debug clock frequency
set CLOCK_FREQ 8000

# Reset configuration
# use hardware reset, connect under reset
# connect_assert_srst needed if low power mode application running (WFI...)
reset_config srst_only srst_nogate connect_assert_srst
set CONNECT_UNDER_RESET 1
set CORE_RESET 0

# ACCESS PORT NUMBER
set AP_NUM 0
# GDB PORT
set GDB_PORT 3333



# BCTM CPU variables

source [find target/stm32f1x.cfg]

# SWV trace
set USE_SWO 0
<<<<<<< HEAD
set swv_cmd "-protocol uart -output :3344 -traceclk 16000000"
=======
set swv_cmd "-protocol uart -output :3344 -traceclk 32000000"
>>>>>>> 0d4186c58a8c7c7f3cb8799f4ec11a6ed44b42c5
source [find board/swv.tcl]