-
Notifications
You must be signed in to change notification settings - Fork 24
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
RJ12 to USB cable in the part list? #16
Comments
+1 please give more detail how you connected Pi to the the controller. Appreciate |
Based on this post on diysolarforum.com, following PINs are used:
I did not use USB, but instead used Pi's GPIO with max3232 RS232 to TTL converter. Oh, and I connected to Renogy Wanderer. |
Thanks, I made a DIY cable, but lately I found this https://www.amazon.com/dp/B07JGRJR4V and I tested it and found working with Renogy Wanderer. Just that I had to use device id as 255, ie: RenogyRover('/dev/tty.usbserial-D309XXXX', 255) |
just a clarification for anyone else following along, there are a few Renogy Rj12 TO DB9 connection images out there that are wrong. as you look at the RJ12 Plug and see the gold pins the numbering starts from left to right 1 - 6, pin 1 is the Renogy's TX pin, pin2 Is the Renogy's RX pin, pin 3 is ground. you should get about 5.6 V when you test TX and GND |
This comment was marked as outdated.
This comment was marked as outdated.
Just a reminder, as this cost me some time to figure out, you may need to find the correct modbus slave address to get this to work.
For me, I had to change the 1 above to a 16. |
Hello, this sounds like a great little project for monitoring Renogy performance. However I was wondering what did you use for connecting RJ12 to USB port of pi? I searched online but did not find any standard rs232 cable built for this purpose. It would be great if you can add the cable used to the part list.
The text was updated successfully, but these errors were encountered: