You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
New to github and unsure how to private message but here goes...
I'm fascinated by the esp8266_lifx code since my harmony remote picks up the emulated device, now in my mind this seems simple but having not worked on the code I'm dumbstruck how to actually implement...
On my remote I have 4 buttons I can assign to certain devices, now the LED light is picked up and I can probably control the device (not sure which pins are controlled on my wemos D1)
my idea is simple in my head, is it possible to emulate 4 devices, on/off would be a specified pin high/log and changing brightness would maybe be another pin voltage lower/higher or PWM lower/higher?
By doing this I can switch on my room lights connected to a relay and the brightness button would not do anything, if I select another "light" which would be my blinds I can select the blind with the I/O going high/low and the "brightness" can be the up/down control.
Is there any way you can help me doing this? again it seems simple in my mind but not understanding the code fully makes it way more difficult to implement. unsure how to go about to get in touch personally and further unsure if im allowed to leave an email address.
Please help!
The text was updated successfully, but these errors were encountered:
Hi,
New to github and unsure how to private message but here goes...
I'm fascinated by the esp8266_lifx code since my harmony remote picks up the emulated device, now in my mind this seems simple but having not worked on the code I'm dumbstruck how to actually implement...
On my remote I have 4 buttons I can assign to certain devices, now the LED light is picked up and I can probably control the device (not sure which pins are controlled on my wemos D1)
my idea is simple in my head, is it possible to emulate 4 devices, on/off would be a specified pin high/log and changing brightness would maybe be another pin voltage lower/higher or PWM lower/higher?
By doing this I can switch on my room lights connected to a relay and the brightness button would not do anything, if I select another "light" which would be my blinds I can select the blind with the I/O going high/low and the "brightness" can be the up/down control.
Is there any way you can help me doing this? again it seems simple in my mind but not understanding the code fully makes it way more difficult to implement. unsure how to go about to get in touch personally and further unsure if im allowed to leave an email address.
Please help!
The text was updated successfully, but these errors were encountered: