-
Notifications
You must be signed in to change notification settings - Fork 38
/
INSTALL_CUSTOM
53 lines (26 loc) · 2.79 KB
/
INSTALL_CUSTOM
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
---- Customising yoshimi ----
There are a number of compile-time options that can be set or edited. These are presented when you run ccmake - after the first time you press 'c'.
Many of these are 'switches' which you toggle on and off. You do this by using the up and down cursor keys to reach the option you want to change, then hit 'Return' to actually change it.
The first of these are the build choices. If these are all off, a basic all-purpose build will take place. Also, these are exclusive, in that you can only have one of them on at a time (even though more may seem to be set).
However, if you know the details of your machine architecture, switch the appropriate one on. Many current desktops as well as laptops are 64 bit Intel ones, so for one of these you would select 'BuildForCore2_X86_64', whereas for the raspberry PI V3 you would chose 'BuildForNEON'.
Alternatively 'BuildForThisCPU' will try to find the best fit for your particular machine.
After these, there are the actual compiler flags that will be used. These should only be changed if there is some specific feature you want enabled or disabled. You select as before by moving the cursor, but this time pressing 'Return' enters a line editor and you move sideways to reach the item you want to change, typing in the new flag, or removing the unwanted one. Pressing 'Return' again puts you back in selection mode.
---- Locations ----
After the main build information you will see the location of the Curses directory (used for command line access). This is where cmake found a valid location and you shouldn't change it unless you have a specific need to use a different library.
---- Other Options ----
'BuildWithFLTK' (normally on) - If disabled you get a headless build with no references to graphical libraries.
There is a switch for building in jack session support.
Yoshimi can be used as an LV2 plugin if switched on, otherwise the code will not be generated. Once again, there is also an editable location. The majority of installs want this located at 'lib/lv2' but if you need something different you can change it.
'ReportNotes' is a developer's tool that counts note-on and note-off events passing through the system to check they tally.
Finally, there is 'ShowNoteOnTimes'. This is an option to display the time it takes for a note to be generated and is again for the benefit of developers.
---- Build for 32 bit ----
Sometimes you want to build for a machine that has a 64 bit processor but is running in 32 bit mode. This is what you need to do.
cd to yoshimi source directory and before and:
mkdir build-32
cd build-32
CC='gcc -m32' CXX='g++ -m32' cmake ../src
make
Remember all lib32- dependencies should be installed prior to building.
---- Help ----
If you get stuck, ask for help on:
<http://www.freelists.org/list/yoshimi>.