Documentation of changes to the project.
- new redundancy feature to check if measured temperature is below desired temperature
- merged to main as last revision in
a234316e
- A 1 second delay after final temperature measurement so user can verify that it is close to desired temperature.
- merged to main in
b8ecdb88
- Changed from 30 second delay to 10 second delay
- Mechanical: new stand configuration, from the file added in commit
07b0906e. It has a cardboard guard rail, and a box to lower the thermometer.
- fixed potentiometer linear interpolation formula to T = ((ADC_Value)*(init_temp-20)/4095)+20, where
- T is temperature mapped by potentiometer
- init_temp is initial temperature measurement
- ADC_Value is raw potentiometer value received by ADC
- merged to main in
673a10b9
- Made procedure work according to original design
- Configured loops and delays
- In commit
f562d5b0 - Schematic: two significant feature changes in commit
514a44f2. This includes:- 10k Ohm Resistors added to SDA/SCL connection with 5V
- Voltage and GPIO pin changes on button and potentiometer
- Mechanical: stand configuration with rail according to original design, in commit
cbe37fea