MPDB Migration

This guide will walk you through how to migrate from MySQLPlayerDataBridge (MPDB) to HuskSync v2.x.

Requirements

• Spigot servers with MySQLPlayerDataBridge still installed

Migration Instructions

1. Install HuskSync v2.x on all Spigot servers

• Download, then install HuskSync on all your servers. Don't uninstall MySQLPlayerDataBridge yet.
• Follow the setup instructions here.
• Start your servers again when done.

2. Configure the migrator

• With your servers back on and correctly configured to run HuskSync v2.x, ensure nobody is online.
• Use the console on one of your Spigot servers to enter: husksync migrate mpdb. If the MPDB migrator is not available, ensure MySQLPlayerDataBridge is still installed.
• Adjust the migration setting as needed using the following command: husksync migrate mpdb set <setting> <value>.
• Note that migration will be carried out from the database you specify with the settings in console to the database configured in config.yml.

3. Start the migrator

• Run husksync migrate legacy start to begin the migration process. This may take some time, depending on the amount of data you're migrating.

4. Uninstall MySQLPlayerDataBridge

• HuskSync will notify in console when migration is complete
• Stop all your Spigot servers and remove the MySQLPlayerDataBridge jar from each of them.
• Start your Spigot servers again.

5. Ensure the migration was successful

. Verify that the migration went OK by logging in and using the /userdata list <username> command to see if the data was imported with the mpdb migration cause.

• You can delete the old tables in the database if you want. Be careful to make sure you delete the correct ones.